Maintenance - Vetus BOW PRO Série Mode D'emploi

4

Maintenance

BOWA0301 - ø 110 mm:
The bow thruster tailpiece has long-term lubrication.
The following maintenance should be carried out during a slipway
service:
• Check the cathodic protection and if necessary renew the zinc
anode.
For the part number of the zinc anode, see page 95.
• Clean the bolts and apply threadlock (eg. Loctite®).
• Clean the propeller shaft, grease with 'outboard gear grease' and
refit the propeller on the shaft.
BOWA0361, BOWA0421 - ø 125 mm
BOWA0572 - ø 150 mm
The bow thruster tailpiece has long-term lubrication.
The following maintenance should be carried out during a slipway
service:
• Check the cathodic protection and if necessary renew the zinc
anode.
For the part number of the zinc anode, see page 96 t/m 98.
• Clean the bolts and apply threadlock (eg. Loctite®).
• Clean the propeller shaft, grease with 'outboard gear grease' and
refit the propeller on the shaft.
16
020810.01
Outboard Gear
Grease
M6
5 - 6 Nm
Outboard Gear
PH2
vetus® Owner's Manual BOW PRO Series Thrusters
Loctite® 242
2.5
M4
1 Nm
5
Grease
Loctite® 242
M5 3
2 Nm