cecotec CONGA 7290 ETERNAL HOME GENESIS Manuel D'instructions page 60

ENGLISH
Charging and replacing the battery
- To extend battery life, leave the robot vacuum cleaner charging on the self-emptying base
whenever not in use.
- Remove the battery and store it in a safe, dry place if the device will not be used for a long
period of time.
- To replace the battery, follow the instructions below:
1. Unscrew the 2 screws on the battery compartment, remove the battery cover and the
battery. Fig 15.
2. Insert the new battery with the battery label facing up.
3. Put the battery and the battery cover in back in place and properly fix the screws back
again.
5. TROUBLESHOOTING
Robot vacuum cleaner
Problem
The robot does not start up or does
not clean.
The robot vacuum cleaner cannot
charge or return to the self-
emptying base.
The robot does not work properly.
The robot emits a strange noise
during cleaning.
60
CONGA 7290 ETERNAL HOME GENESIS
Possible cause and solution
The robot does not operate when the battery is low.
Allow it to charge before operation.
The room temperature is below 0ºC or above 40ºC.
There are too many obstacles near the self-emptying
base. Relocate the charging base to an area free of
obstacles.
Clean the charging terminals on both the charging base
and the robot.
Make sure the robot vacuum cleaner is on.
The robot vacuum cleaner is too far away from the self-
emptying base. Place it closer and try again.
Turn off the robot vacuum cleaner and turn it on again.
Reset the robot by pressing the reset side button.
The main brush, side brush, or omnidirectional wheel
may be blocked or tangled. Stop the robot and clear
them up.