cecotec CONGA 7290 ETERNAL HOME GENESIS Manuel D'instructions page 58

ENGLISH
Robot vacuum cleaner's Location function
Allows to locate the robot vacuum cleaner on the map.
4. CLEANING AND MAINTENANCE
Main brush cleaning
The main brush spins at top speed and helps introduce dirt into the suction nozzle. This brush
is in contact with the floor, and therefore with dirt, so it can be worn out over time, affecting
negatively to the cleaning efficiency. Therefore, it is recommended to change the main brush
maximum every 320 hours or less.
1. Slightly press the main brush frame's tabs to open the main brush compartment and
remove it. Fig. 10
2. Remove hair, lint, and other dirt trapped in the brush and around the shafts with the help
of the self-cleaning brush. Fig. 11
3. Clear and clean the robot vacuum cleaner's suction channel.
4. Reinstall the main brush and its frame.
Recommendation
It is recommended to clean the main brush once a week with the help of the self-cleaning
brush.
Side brushes. Fig. 12
Side brushes are designed with multiple bristles and are used to push dirt towards the suction
mouth and to thoroughly clean edges and corners. These brushes can wear out over time,
negatively affecting cleaning efficiency.
Recommendation
- It is recommended to clean the side brushes once a week with the help of the self-cleaning
brush.
- Remove the side brushes by pulling them outwards and clean them regularly.
Recommendation
In order to ensure a perfect cleaning, it is suggested to replace the side brushes every 3
months, depending on the frequency and type of use.
Mixed tank. Fig. 13:
- Take the Wet & dry tank out.
- Open the mixed tank cover and empty it.
- Remove the filter and filter holder as shown in figure 13.
- Use the cleaning brush to clean the inside of the mixed tank.
- You can clean the dust compartment with water, without immersing the tank.
- Reinstall the mixed tank on the robot vacuum cleaner.
58
CONGA 7290 ETERNAL HOME GENESIS