Parts Description - Makita AF353 Manuel D'instruction

Symbols
The followings show the symbols used for tool.
Read and understand tool labels and man-
ual. Failure to follow warnings could result
in death or serious injury.
Operators and others in work area must
wear safety glasses with side shields.
Keep fingers away from trigger when
not driving fasteners to avoid accidental
discharge.

PARTS DESCRIPTION

2
4
► 1. Lock lever 2. Trigger 3. Hook 4. Nose adapter
5. Sliding door
INSTALLATION
Selecting compressor
1.5
1.3
1.1
0.9
2
0.7
0.5
0.3
0.1
0 10
1. Nailing frequency (times/min) 2. Compressor air out-
3
put per minute (CFM (ft
4. 0.57 MPa (85 PSIG) 5. 0.45 MPa (65 PSIG)
1
5
20 30 40 50
1
/min.)) 3. 0.69 MPa (100 PSIG)
The air compressor must comply with the requirements
of ANSI B19.3.
Select a compressor that has ample pressure and air
output to assure cost-efficient operation. The graph
shows the relation between nailing frequency, applica-
ble pressure and compressor air output.
Thus, for example, if nailing takes place at a rate of
approximately 50 times per minute at a compression of
0.69 MPa (100 PSIG), a compressor with an air output
over 0.9 CFM ( ft
Pressure regulators must be used to limit air pressure to
the rated pressure of the tool where air supply pressure
exceeds the tool's rated pressure. Failure to do so may
result in serious injury to tool operator or persons in the
vicinity.
Selecting air hose
CAUTION:
or a long or smaller diameter air hose in relation
to the nailing frequency may cause a decrease in
the driving capability of the tool.
3
Use an air hose as large and as short as possible to
assure continuous, efficient nailing operation.
With an air pressure of 0.49 MPa (70 PSIG), an air hose
with an internal diameter of over 6.5 mm (1/4") and a
length of less than 20 m (6.6 ft.) is recommended when
the interval between each nailing is 0.5 seconds.
Air supply hoses shall have a minimum working pres-
sure rating of 1.03 MPa (150 PSIG) or 150 percent of
the maximum pressure produced in the system which-
ever is higher.
3
Lubrication
4
5
4 ENGLISH
3
/minute) is required.
Low air output of the compressor,