Functional Description - Makita AF353 Manuel D'instruction

To insure maximum performance, install an air set (oiler,
regulator, air filter) as close as possible to the tool.
Adjust the oiler so that one drop of oil will be provided
for every 50 nails.
When an air set is not used, oil the tool with pneumatic
tool oil by placing 2 (two) or 3 (three) drops into the air
fitting. This should be done before and after use.
For proper lubrication, the tool must be fired a couple of
times after pneumatic tool oil is introduced.
► 1. Pneumatic tool oil
FUNCTIONAL
DESCRIPTION
CAUTION:
Before adjusting or checking func-
tion on the tool, always return the trigger and lock
lever and disconnect the hose.
Trigger and lock lever
WARNING:
Make sure that your fingers are
not placed on the trigger and lock lever when con-
necting the hose. Otherwise the tool may misfire
and result in personal injury.
The tool is equipped with a lock lever to prevent the
trigger from pulling accidentally.
To drive the pin nails, first pull the lock lever, and then
pull the trigger.
► 1. Lock lever
1
1
5 ENGLISH
► 1. Trigger
Checking safety system
WARNING:
Make sure all safety systems are
in working order before operation. Failure to do so
may cause personal injuries.
CAUTION:
Make sure that the tool is not
loaded with pin nails.
► 1. Trigger 2. Lock lever
Before pin nailing operation, check the safety system
as follows:
1.
Pull the sliding door of the magazine toward your-
self to release the anti dry fire mechanism.
2. Unload the tool.
3. Make sure that you cannot pull the trigger when
the lock lever is not pulled.
4. Make sure that you can pull the trigger after you
pull the lock lever.
If the tool fails the check above, stop using the tool and
ask authorized service center for repairing.
1
2
1