Makita AF353 Manuel D'instruction page 7

► 1. Unlock button 2. Sliding door
2. Place pin nails against the magazine and insert
into the slit all the way. Be careful to place pin nails in
the right direction.
3. Keeping pin nails in this position, slide these nails
all the way into the driver guide.
2
► 1. Pin nails 2. Driver guide
4. Return the magazine to the original position until
unlock button pops up.
Unloading pin nailer
To remove pin nails, follow the procedures of "Loading
pin nailer" in reverse.
Nose adapter
When driving pin nails on delicate surfaces, use the
nose adapter.
To install the nose adapter, place it over the driver guide
cover so that the protrusions inside the nose adapter fit
in the driver guide cover.
1
2
A spare nose adapter is stored in the holder at the end
of the sliding door.
Connecting air hose
1
► 1. Air fitting 2. Air socket
Slip the air socket of the air hose onto the air fitting on
the nailer. Be sure that the air socket locks firmly into
position when installed onto the air fitting.
A hose coupling must be installed on or near the tool in
such a way that the pressure reservoir will discharge at
the time the air supply coupling is disconnected.
7 ENGLISH
1
2