Makita AF353 Manuel D'instruction page 8

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATION
CAUTION:
Make sure all safety systems are in
working order before operation.
Driving pin nails
WARNING:
Make sure to contact the nose
against the material before pulling the trigger.
Misfiring may result in personal injury.
1.
Place the nose on the material flatly, and hold the
tool firmly against the material.
2.
Pull the lock lever, and pull the trigger fully to drive
the pin nail.
3.
After driving a pin nail, be sure to release the
trigger and lock lever fully.
If the head of driven pin nail remains above the surface
of material, hold the pin nailer head firmly when driving
the pin nail.
NOTE: When the trigger is pulled after a quick trig-
ger action, the nailer may do nothing but operates
momentarily and not fire pin nail. In that case, release
the trigger and the lock lever fully before driving the
pin nail again.
NOTICE:
Do not use deformed nails or nail strip.
Failure to do so causes poor nail feeding.
Anti dry fire mechanism
This tool is equipped with an anti dry fire mechanism.
When there are a few nails remaining in the magazine,
the trigger will be locked in the undepressed position to
prevent the tool from being activated. When it is acti-
vated, load more nails to resume operation.
Empty indicator
When the remaining number of nails in the magazine
becomes low, the empty indicator turns to red. Reload
the nails when the empty indicator becomes red.
► 1. Empty indicator
Removing jammed pin nails
WARNING:
Always return the trigger and lock
lever and disconnect the hose before removing
jammed nails.
When a pin nail is jammed, remove the pin nail as fol-
lows. Make sure to disconnect the hose before remov-
ing the jammed nails.
2
► 1. Bolt (A) 2. Bolt (B) 3. Driver guide cover
1.
Take out pin nails that remain inside the magazine.
2.
Remove the nose adapter.
3.
Loosen bolt (A) and bolt (B) by turning them
approximately two turns using the hex wrench provided
with the pin nailer.
4.
Remove driver guide cover by sliding it.
5.
Remove stuck pin nails, debris, adhesives and
woodchips etc. from the passage for pin nails.
8 ENGLISH
1
1
3

Publicité

Table des Matières
loading

Table des Matières