Parts Description - Makita AN634H Manuel D'instruction

WARNING:
MISUSE or failure to follow the
safety rules stated in this instruction manual may
cause serious personal injury.
Symbols
The followings show the symbols used for tool.
Read and understand tool labels and man-
ual. Failure to follow warnings could result
in death or serious injury.
Operators and others in work area must
wear safety glasses with side shields.
Keep fingers away from trigger when
not driving fasteners to avoid accidental
discharge.

PARTS DESCRIPTION

1
2
► 1. Trigger 2. Trigger lock lever 3. Hook 4. Magazine
cap 5. Nose adapter (contact element)
4
5
INSTALLATION
Selecting compressor
5
4
3.5
3
2
2
1
0
0 10
1. Nailing frequency (times/min) 2. Compressor air out-
put per minute (CFM (ft
4. 1.76 MPa (250 PSIG) 5. 1.18 MPa (170 PSIG)
The air compressor must comply with the requirements
of ANSI B19.3.
Select a compressor that has ample pressure and air
output to assure cost-efficient operation. The graph
shows the relation between nailing frequency, applica-
ble pressure and compressor air output.
3
Thus, for example, if nailing takes place at a rate of
approximately 50 times per minute at a compression of
1.76 MPa (250 PSIG), a compressor with an air output
over 3.5 CFM ( ft
Pressure regulators must be used to limit air pressure to the
rated pressure of the tool where air supply pressure exceeds
the tool's rated pressure. Failure to do so may result in seri-
ous injury to tool operator or persons in the vicinity.
Selecting air hose
CAUTION:
or a long or smaller diameter air hose in relation
to the nailing frequency may cause a decrease in
the driving capability of the tool.
Use a high pressure resistant air hose.
Use an air hose as large and as short as possible to
assure continuous, efficient nailing operation.
4 ENGLISH
20 30 40
1
3
/min.)) 3. 2.26 MPa (320 PSIG)
3
/minute) is required.
Low air output of the compressor,
3
4
5
50 60