Bosch GCM12SD Consignes D'utilisation/De Sécurité page 53

2610051827 GCM12SD 08-18.qxp_GCM12SD 9/19/18 2:52 PM Page 53
Note: Always place top
edge against fence
Inside Corner -
Left end
Use the left end of the cut
Right end
Use the right end of the cut
Outside Corner -
Left end
Use the left end of the cut
Right end
Use the right end of the cut
.800.544.2843
Miter and Bevel Settings for Standard Crown Molding Cuts
Assumptions: Molding is milled consistently. Corner is exactly 90°.
Inside
Corner
Ceiling
38°
38° Spring Angle
www.calcert.com
15
10 20
5 25
30
0
Saw Operations
(With Molding Flat on Table)
Molding Spring Angle 38º
Miter (Table) Bevel (Tilt)
Setting Setting
31.6º Right 33.9º Left
31.6º Left 33.9º Right
31.6º Left 33.9º Right
31.6º Right 33.9º Left
Outside
Corner
52°
38/52° Crown
Molding
Molding Spring Angle 45º
Miter (Table)
Setting
35.3º Right
35.3º Left
35.3º Left
35.3º Right
Fence
Top of Molding
Against Fence
Table
Ceiling
45°
45°
45/45° Crown
Molding
45° Spring Angle
sales@calcert.com
Bevel (Tilt)
Setting
30º Left
30º Right
30º Right
30º Left
53