Bosch GCM12SD Consignes D'utilisation/De Sécurité page 45

2610051827 GCM12SD 08-18.qxp_GCM12SD 9/19/18 2:52 PM Page 45
Bevel range selector knob – This saw has a front control on the right side of the table arm. This
is called the bevel range selector knob (item 41 – page 12). It is linked to stops and locking mech-
anisms in the rear which control the tool's ability to quickly and accurately be positioned to make
bevel cuts. There are positive stops at the important 45° left, 0° (vertical), and 45° right angles
(see Figure 49).
Using the Bevel Range Selector Knob
Bevel Range 1 = 0-45° Left
This left-side bevel range is the default setting.
To operate in Bevel Range 1:
1. Move the left sliding fence out to clear saw
assembly and relock (Figure 51).
2. Lift bevel lock lever above table height with
left hand.
3. Grasp the main handle with the right hand
and tilt the saw assembly to the angle de-
sired.
.800.544.2843
Saw Operations
Bevel Range Selector Knob
www.calcert.com
15
10 20
5 25
30
0
Bevel Cuts
Right Side of Table
4. Once in the desired bevel position, hold the
saw assembly with right hand and use left
hand to fully press down the bevel lock lever
below table height.
NOTE: Without turning the saw "ON", perform
a dry cut to make sure the fence clears the
guards and adjust if necessary.
Fig. 49
45
sales@calcert.com