Publicité
Les langues disponibles
Les langues disponibles
COMPUTER MANUAL
DISPLAYS
COMPUTER:
[KM/H] Display: Shows actually speed in Km/h.
[CAL./INCL.] Display: Shows approx calories in kcal and the
set incline level in alternation.
[TIME] Display: Shows actually time of exercising in minutes
and seconds.
[KM] Display: Shows actually distance in Km.
CONTROL KNOB:
Program selection mode:
Program selection mode:
You can choose between the following programs by turning
the control knob.
[QUICK-START] Manual program
[TARGET TIME] Time program
[TARGET DISTANCE] Distance program
[TARGET CALORIES] Calorie program
[PROGRAM 1-15] Speed programs 1-15
Program default mode:
The long press jumps the display in the selected program into
[SET] mode. There you can set the target value.
Training mode:
The training data are displayed alternately here.
[Time] Shows how long you ran in minutes and seconds.
[DISTANCE] Shows how far you have run in kilometers
[CALORIES] Shows actually calories in kcal.
[-♥-] Shows the measured heart rate. (Only if you keep your
hands on the heart rate sensors or use an optional heart
rate belt.)
[Program Diagrams] Shows only in programs 1-15.
Bottom left display. Shows the set speed of the treadmill in
kilometers per hour.
Bottom right display. Shows the set incline.
[PAUSE] Shows that the training has been paused.
[SLEEP] Shows that the treadmill is in sleep mode.
[SAFE] Shows that the safety clip is not installed.
CONTROLS
CONTROL KNOB:
[Short press]
- Start/Stop
[Long press]
- Open the preferences menu
- Close the default menu
- Pause
[Rotate clockwise]
- Increase the speed
- Scroll forward in the program menu
- Increase the default values
[Rotate counterclockwise]
- Decrease in speed
- Scroll backwards in the program menu
- Decrease the default value
[Push and hold and rotate clockwise]
- Increasing the incline
[Push and hold and rotate counterclockwise]
- Decrease the incline
SENSORS FOR GESTURE CONTROL:
[Both Sensors] Start / Stop
[ - Sensor left ] Decrease in speed
[ + Sensor right ] Increase in speed
RANGE OF ALL FUNCTIONS
Initial
TIME (Min:Sec)
0:00
KM/H
0.0
KM
0.00
PULSE
-♥-
CALORIES (Kcal) 0
START UP
1. Plug the mains plug into a properly installed socket
(230V~50Hz) and switch on the main switch (84) at the bottom
front of the treadmill.
2. Stand on the side rails.
3. Put the safety clip on your training clothes (e.g. waisband) and
in the corresponding holder on the computer and the computer
will show you the [QUICK-START] program and you are ready
to start.
20
Initial
Setting
Display
Value
Range
Range
30:00
5:00-99:00
0:00-99:59
N/A
N/A
1.0-16.0
1.00
0.5-65.0
0.00-65.0
N/A
N/A
50-200
50
10-995
0-999
GB
Publicité
