Briggs & Stratton GenAlert Mode D'emploi page 7

Installation
If your home has specially wired alarm equipment
connected to the telephone line, ensure the installation
of your GenAlert Plus does not disable your alarm
equipment. If you have questions about what will
disable alarm equipment, consult your alarm system
installer.
Items Required for Installation
• One 9-Volt alkaline or lithium battery
(not included)
• Phillips screwdriver (not included)
• 2 conductor wire
(20 AWG or larger, not included)
• A single line telephone jack
The telephone line does not need to be a dedicated
phone jack. A phone can share the jack with GenAlert
through the use of a telephone line splitter (not
included).
Installation
1. Remove four cover screws (A) from back cover.
2. Attach the 9V battery to connector (B) and place
battery in the battery compartment (C).
3. Locate the four DIP switches (D) on the circuit
board (E).
A
E
D
A
D
Get other manuals https://www.bkmanuals.com
A
B
A
C
5