Briggs & Stratton GenAlert Mode D'emploi page 10

Controls
8
A - Front Cover.
B - Key Pad.
C - Star Key.
D - LED Light.
E - Pound Key.
F - Telephone Connector Jack.
F
A
B
C
D
Get other manuals https://www.bkmanuals.com
Operation
Programming GenAlert
The programmed telephone number is the number
you want your GenAlert to call if your home standby
generator fails during operation. The phone number
is remembered even if you disconnect the battery and
the phone line from the unit.
You may program up to forty (40) digits in a phone
number. The pound key (E) and star key (C) are used
to program and test GenAlert.
Before programming, make sure your phone line is
connected to GenAlert and the wall telephone jack.
1. Press and hold the pound key (E) on the
GenAlert's keypad.
2. While holding the pound key (E), use the keypad
(B) to enter the telephone number you want
GenAlert to call.
Keep holding down the pound key (E) until the entire
E
phone number is entered.
BRIGGSandSTRATTON.COM