Husqvarna 545 Mark II Manuel D'utilisation page 7

the front hand guard (B) forward to engage the chain
brake manually.
Pull the front hand guard rearward to disengage the
chain brake.
Chain brake and rear brake trigger (550XP Mark II
TrioBrake, 550XPG Mark II TrioBrake)
CAUTION:
rear brake trigger. This can cause damage
to the product.
Your product has a rear brake trigger that stops the
saw chain if you get a kickback. The rear brake trigger
decreases the risk of accidents, but only you can
prevent them.
The chain brake (A) engages manually by your right
hand when the rear brake trigger (B) is pushed up.
B
Pull the front hand guard (C) rearward to disengage the
chain brake.
Throttle trigger lockout
The throttle trigger lockout prevents accidental operation
of the throttle trigger. If you put your hand around
the handle and press the throttle trigger lockout (A),
it releases the throttle trigger (B). If you release the
handle, the throttle trigger and the throttle trigger lockout
move back to their initial positions. This function locks
the throttle trigger at idle speed.
544 - 011 - 09.11.2023
B
A
Do not lift the product by the
C
A
A
B
Chain catcher
The chain catcher catches the saw chain if it breaks or
derails. Correct saw chain tension and correctly applied
maintenance on the saw chain and guide bar, decrease
the risk of accidents.
Right hand guard
The right hand guard is a protection for your hand on the
rear handle. The right hand guard gives you protection
if the saw chain breaks or derails. The right hand guard
also gives you protection from branches or twigs.
Vibration damping system
The vibration damping system decreases vibration in
the handles. Vibration damping units operate as a
separation between the product body and the handle
unit.
Product overview on page 2 for information
Refer to
about where the vibration damping system is on your
product.
7