EXFO FTB-1v2 Guide De L'utilisateur page 484

Communicating Through TCP/IP Over Telnet
Executing SCPI Commands Over Telnet
2. Enter the desired SCPI commands as follows:


3. Click
472
For a single SCPI command: Type or copy the desired command in
the Telnet editor window, and then press ENTER to execute it.
For multiple SCPI commands: Copy the desired commands from
any script file, enclose them in a BEGIN and END block in the
Telnet editor window, and then press ENTER. For more
information, see Internal Commands of the TCP/IP over Telnet
Protocol on page 477.
to close the session.
FTB-1v2 and FTB-1v2 Pro