EXFO FTB-1v2 Guide De L'utilisateur page 460

SCPI-Based Errors
Error
Description
Number
–210 "Trigger error"
–211 "Trigger ignored"
–212 "Arm ignored"
–213 "Init ignored"
–214 "Trigger deadlock"
–215 "Arm deadlock"
–220 "Parameter error"
–221 "Settings conflict"
448
Probable Cause
-----
Indicates that a GET, *TRG, or triggering signal was
received and recognized by the device but was
ignored because of device timing considerations;
for example, the device was not ready to respond.
Note: a DT0 device always ignores GET and treats
*TRG as a Command Error.
Indicates that an arming signal was received and
recognized by the device but was ignored.
Indicates that a request for a measurement
initiation was ignored as another measurement
was already in progress.
Indicates that the trigger source for the initiation of
a measurement is set to GET and subsequent
measurement query is received. The
measurement cannot be started until a GET is
received, but the GET would cause an
INTERRUPTED error.
Indicates that the arm source for the initiation of a
measurement is set to GET and subsequent
measurement query is received. The
measurement cannot be started until a GET is
received, but the GET would cause an
INTERRUPTED error.
Indicates that a program data element related error
occurred. This error message should be used
when the device cannot detect the more specific
errors described for errors –221 through –229.
Indicates that a legal program data element was
parsed but could not be executed due to the
current device state (see IEEE 488.2, 6.4.5.3 and
11.5.1.1.5).
FTB-1v2 and FTB-1v2 Pro