EXFO FTB-1v2 Guide De L'utilisateur page 239

3. If you want to send SCPI commands to your modules, select the Allow
automation on instruments check box. Clear the check box if you
prefer to block automation on your unit.
Note: If you allow automation, all modules in your unit will be initialized upon
startup so you are ready to send remote commands.
Before being able to control instruments with SCPI commands, you
must also allow remote access to these instruments. For more
information, see Configuring Your Instruments on page 254.
If you cleared the check box because you prefer to block automation,
you can go directly to step 6.
FTB-1v2 and FTB-1v2 Pro
Preparing for Automation
Changing Communication Settings
I
MPORTANT
227