Télécharger Imprimer la page

Panasonic NN-SD382S Manuel D'instructions page 12

Publicité

Les langues disponibles

Les langues disponibles

IP3899_3BA60CP_30_120302 2012-3-2 Jerry
Care and Cleaning of your Microwave Oven
BEFORE CLEANING:
Unplug oven at wall outlet. If outlet is inacces-
sible, leave oven door open while cleaning.
Menu Label/Warning Label:
Do not remove, wipe with a
damp cloth.
Inside of the oven:
Wipe with a damp cloth
after using. Mild detergent
may be used if needed.
Do not use harsh deter-
gents or abrasives.
Oven door:
Wipe with a soft, dry
cloth when steam
accumulates inside or
around the outside of
the oven door. During
cooking, especially
under high humidity
conditions, steam is
given off from the
food. (Some steam
will condense on cool-
er surfaces, such as
the oven door. This is
normal.)
Inside surface is cov-
ered with a heat and
vapor barrier film. do
not remove.
IT IS IMPORTANT TO kEEP THE OVEN CLEAN ANd dRy.
FOOd RESIdUE ANd CONdENSATION MAy CAUSE RUST-
ING OR ARCING ANd dAMAGE TO THE OVEN. AFTER USE,
WIPE dRy ALL SURFACES-INCLUdING VENT OPENINGS,
OVEN SEAMS, ANd UNdER GLASS TRAy.
9:04 Page 10
All manuals and user guides at all-guides.com
Glass Tray:
Remove and wash in warm soapy
water or in a dishwasher.
Roller Ring and oven cavity floor:
Clean the bottom surface of the oven
with mild detergent water or window
cleaner, and dry. Roller Ring may be
washed in mild soapy water or dish-
washer. These areas should be kept
clean to avoid excessive noise.
10
AFTER CLEANING:
Be sure to place the Roller Ring and the
Glass Tray in the proper position and press
Stop/Reset Button to clear the Display.
Outside oven surfaces:
Clean with a damp cloth.
To prevent damage to the
operating parts inside the
oven, water should not be
allowed to seep into ventila-
tion openings.
Control Panel:
• Covered with a
removable protective
film to prevent
scratches during
shipping. Small bub-
bles may appear
under this film.
(Hint - To remove
film, apply masking
or clear tape to an
exposed corner and
pull gently.)
• If the Control Panel
becomes wet, clean
it with a soft, dry
cloth. Do not use
harsh detergents or
abrasives.
do not remove waveguide cover:
It is important to keep cover
clean in the same manner as the
inside of the oven.

Publicité

loading