Publicité
Les langues disponibles
Les langues disponibles
Inserting/removing the battery pack
Inserting the battery pack
♦
Set the rotation direction switch 7 to the middle
position (lock). Push the battery pack e into
the handle until it clicks into place.
Removing the battery pack
♦
Press the release button r and remove the
battery pack e.
Checking the battery charge level
♦
Press the battery charge level button u to
check the status of the battery. The status/
remaining charge will be shown on the battery
display LED z as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Additional handle
NOTE
►
For safety reasons, you should never use
this tool without the additional handle 1
attached.
♦
Loosen the strap on the additional handle 1
by turning it clockwise.
♦
Slide the mounting ring for the additional
handle 4 over the chuck w.
♦
Turn the additional handle 1 to the required
position.
♦
Afterwards, twist the additional handle 1
anticlockwise again to tighten it.
Depth stop
♦
Undo the screw on the depth stop 5.
♦
Fit the depth stop 2 into the additional
handle 1.
♦
Make sure that the teeth on the depth stop 3
point upwards and downwards.
8
■
│
GB │ IE
♦
Pull the depth stop 2 out until the distance
between the tip of the drill and the tip of the
depth stop corresponds with the required
drilling depth.
♦
Tighten the screw on the depth stop 5 to
lock the depth stop 2 into place.
Changing tools
Your cordless impact drill driver has a fully auto-
matic spindle lock
When the motor is stopped, the power train is
locked so that the chuck w can be opened by
turning
. After you have attached the desired
tool and tightened it by turning the chuck
can continue working. The spindle lock is released
automatically when the motor is started (by pressing
the ON/OFF switch 8).
Torque selection/selecting
the operating mode
You can set the torque using the torque selection
ring q or by choosing between the drill setting
and the hammer drill setting
♦
Select a low level for small screws or soft
materials.
♦
Select a high level for large screws, hard
materials or removing screws.
♦
Select the drill setting for drilling work by adjusting
the torque selection ring to the position .
♦
Select the hammer drill setting for hammer drilling
work by adjusting the torque selection ring to
the position
.
2-speed gearbox
CAUTION!
►
Operate the speed selector switch 6 only
when the tool is at a standstill. Otherwise,
the tool could be damaged.
In first gear
(speed selector switch 6 in position 1),
you can reach a speed of approx. 400 rpm and a
high torque. This setting is suitable for all screwing
work.
.
, you
.
PSBSAP 20-Li B3
Publicité
