Setting The Clock; Detaching The Front Panel; Attaching The Front Panel - Sony CDX-GT730UI Mode D'emploi

Setting the clock

The clock uses a 24-hour digital indication.
1
Press and hold the select button.
The setup display appears.
2
Rotate the control dial until "Clock
Adjust" appears.
3
Press the select button.
4
Rotate the control dial to set the hour,
then press the select button.
5
Rotate the control dial to set the
minute, then press the select button.
To move the digital indication, press the
select button/ (back) +/–.
The setup is complete and the clock starts.
Tip
You can set the clock automatically with the RDS
feature (page 14).

Detaching the front panel

You can detach the front panel of this unit to
prevent theft.
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound if the built-in
amplifier is used.
1
Press (OFF).
The unit is turned off.
2
Press (OPEN).
The front panel is flipped down.
3
Slide the front panel to the right, then
gently pull out the left end of the front
panel.
Notes
• Do not drop or put excessive pressure on the front
panel and display window.
• Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a parked
car or on a dashboard/rear tray.
• Do not detach the front panel during playback of the
USB device, otherwise USB data may be damaged.

Attaching the front panel

Place the hole A of the front panel onto the
spindle B on the unit, then lightly push the left
side in.
Press (SOURCE) on the unit (or insert a disc) to
operate the unit.
Note
Do not put anything on the inner surface of the front
panel.
7