Selecting The Location; Leveling The Balance; Connecting Power - OHAUS Scout STX123 Mode D'emploi

STX
2.2

Selecting the Location

For best performance, the Scout balance should be used in a clean, stable environment. Do not
use the balance in environments with excessive drafts, with rapid temperature changes, near
magnetic fields or near equipment that generates magnetic fields, or vibrations.

2.3 Leveling the Balance

The Scout has an illuminated level indicator as a reminder that
the balance should be leveled for accurate weighing. There is a
level bubble in a small round window on the front of the
balance. To level the balance, adjust the feet at each corner
until the bubble is centered in the circle.
Be sure the balance is level each time its location is changed.
See the Level Assist screen in the User Settings Menu.

2.4 Connecting Power

AC Adapter Installation
AC power is used to power the balance when battery power is not needed. First, connect the
AC Adapter (supplied) to the AC Adapter Input jack at the rear of the balance then connect the
AC plug to an electrical outlet.
Interface Connection
Battery Installation
Install the four "AA" batteries with polarity as shown in the battery compartment.
Note:
After power on, it is recommended to let the balance warm up for at least 5 minutes before
using it.
1.800.561.8187
AC Adapter Input Jack
Security slot (Anti-theft lock slot)
www.
Weigh Below Hole
Security Switch
Battery Compartment Cover
information@itm.com
.com
EN-3