Section 3 - Cleaning & Maintenance Cleaning; Cleaning External Parts - Keurig Hot K3000SE Manuel D'utilisation

SECTION 3

Cleaning External Parts

Regular cleaning of the brewer's external components is recommended.
The following section provides instruction for standard cleaning procedures.
Never immerse the brewer in water or other liquids. The Housing
1.
and other external components may be cleaned with a damp, soapy,
lint-free, non-abrasive cloth.
2. The Drip Tray can accumulate up to 10 ounces of overflow. The Drip Tray
and Drip Tray Plate should be periodically inspected and rinsed clean.
To remove the Drip Tray Assembly, simply slide it toward you (fig. 18),
keeping it level at all times to avoid spilling. The Drip Tray and Drip Tray
Plate should not be placed in the dishwasher. They should be cleaned
with a damp, soapy, lint-free, non-abrasive cloth and rinsed thoroughly.
Cleaning the K-Cup
15
fig.
Holder Assembly
1. Cleaning the Parts —
Assembly can be placed onto the top shelf of a
dishwasher.
in the dishwasher.
Holder Assembly from the brewer, open the
cover by lifting the Handle. Grasp the top of the
K-Cup
grasping and squeezing the clips at the back of
Cleaning & Maintenance
Pod
®
The K-Cup Pod Holder
®
NOTE: Use low temperature cycles
To remove the K-Cup
Pod Holder with one hand while
®
fig.
!
paper clip or similar tool. Remove the K-Cup
detach Funnel. Insert the paper clip (fig. 16) into the Exit Needle to loosen the
clog, then flush with water. The K-Cup
onto the top shelf of a dishwasher.
the dishwasher.
CAUTION: There are sharp needles that puncture the K-Cup
Pod
®
K-Cup Pod Holder and in the bottom of the K-Cup
®
of injury, do not put your fingers in the K-Cup
12
the K-Cup Pod Holder (fig. 15). Lift the entire
®
16
K-Cup Pod Holder Assembly away from the
®
puncture mechanism. After cleaning, align the
K-Cup Pod Holder with the opening using the
®
two front ribs as a guide and snap them into
place from the top.
The Funnel can
2. Cleaning the Funnel —
beremoved from the K-Cup
pulling on it until it pops off (fig. 16). The Funnel
is dishwasher safe. To replace it, just snap it
back onto the K-Cup Pod Holder Assembly.
®
3. Cleaning the Exit Needle —
located on the inside bottom of the K-Cup
Holder Assembly. Should a clog arise due
to coffee grinds, it can be cleaned using a
Pod Holder Assembly and
®
Pod Holder Assembly can be placed
®
NOTE: Use low temperature cycles in
Pod Holder. To avoid risk
®
Pod Assembly Housing.
®
Pod Holder by
®
The Exit Needle is
Pod
®
pod above the
®