Hilti DX 5 SM Mode D'emploi page 10

▶ Keep the grips dry, clean and free from oil and grease.
▶ Do not use the tool in places where there is a risk of fire or explosion unless the tool is specially approved
for this type of use.
▶ Never drive fasteners into existing holes unless this is recommended by Hilti (e.g. DX-Kwik).
Workstation
▶ Keep the workplace tidy. Objects which could cause injury should be removed from the working area.
◁ Untidiness in the working area can lead to accidents.
▶ Make sure that the working area is well lit and well ventilated.
Mechanical safety rules
▶ Do not tamper with or modify the tool or parts of it, especially the piston.
▶ Use only fasteners of a type approved for use with the tool.
Thermal safety rules
▶ Do not exceed the recommended maximum fastener driving rate.
▶ If the tool has overheated, allow it to cool down.
▶ Do not dismantle the tool while it is hot. Allow the tool to cool down.
▶ Allow the tool to cool down if the plastic cartridge strip begins to melt.
Risk of explosion with cartridges
▶ Use only cartridges of a type approved for use with the tool.
▶ Remove the cartridge strip from the tool when you have completed the work or before transporting the
tool.
▶ Never attempt to forcibly remove cartridges from the magazine strip or tool.
▶ Store unused cartridges in a secure place where they are not exposed to dampness or excessively high
temperatures.
3 Description
3.1 Overview of the product
4 English
Printed: 02.08.2018 | Doc-Nr: PUB / 5292661 / 000 / 02
1
@
;
=
%
&
(
)
+
§
/
:
∙
$
£
|
¡
Q
W
E
R
T
Exhaust gas piston return unit
Guide sleeve
Casing
Cartridge guideway
Power regulation wheel release button
Power regulation wheel
Display
Pushbutton
Hand pad
Trigger
Operating button
Air vents
Piston rings
Piston
Fastener guide
Magazine
Loading / unloading button
Flat brush
Large round brush
Small round brush
Ramrod
2147995
*2147995*