Genesis GRS550 Manuel D'utilisation page 8

SPECiFiC SaFETY RULES FOR RECiPROCaTing SaWS
WaRning:
DO nOT allow familiarity with the Reciprocating Saw from repeated
use replace strictly following all operating rules. if the tool is
used unsafely or incorrectly, you or a bystander can suffer serious
personal injury!
WaRning:
Hold tool by insulated gripping surfaces when performing an
operation where cutting tools may contact hidden wiring or its own
cord. Contact with a "live" wire will make exposed metal parts of the
tool "live" and shock the operator!
1. Always wear safety glasses or goggles. Normal prescription eye or sunglasses are
not safety glasses.
2. hold the Reciprocating Saw by its insulated gripping surfaces to avoid electrical
shock from unseen "live" wires.
3. Always hold the tool firmly. DO NOT leave the tool running unless hand held.
4. Check your work area for proper clearances before cutting. This will avoid cutting
into your workbench, the floor, etc.
5. Do not cut oversized work pieces.
6. DO NOT cut nails or screws unless you are using a blade specifically designed for
this purpose. Inspect your material before cutting.
7. Before switching on the tool, be sure the blade is not contacting the workpiece.
8. Keep hands away from moving parts and on the top surface of the workpiece. Do
not place hands below work surface while saw is operating.
9. Always allow the blade to completely stop before removing from the workpiece. Do
not touch the blade, it is hot and may cause a serious burn.
OPERaTiOn
WaRning:
always check that the power supply corresponds to the voltage on
the rating name plate.
WaRning:
To avoid accidental start, check to make sure Lock-on button is not
engaged prior to plugging in tool and your finger is not touching the
on/off switch.
RECIpROCAtInG SAW
Operator's Manual GRS550