Searching A Track By Listening To Track Passages - Zappin; Sound Settings And Setup Menu; Changing The Sound Settings; Adjusting The Sound Characteristics - Sony CDX-GT450U Mode D'emploi

To cancel Jump mode
(BACK) or (SEEK) –.
Press
Note
If no operation is performed for 7 seconds, the Jump
mode is canceled.
Searching a track by listening
to track passages — ZAPPIN™
While playing back short track passages in a CD
or USB device in sequence, you can search for a
track you want to listen to.
ZAPPIN mode is suitable for searching for a
track in shuffle or shuffle repeat mode.
1
Press (ZAP) during playback.
After "ZAPPIN" appears in the display,
playback starts from a passage of the next
track.
The passage is played for the set time, then a
click sounds and the next passage starts.
Track
(ZAP) pressed.
2
Press the select button or (ZAP) when
a track you want to listen is played
back.
The track that you select returns to normal
play mode from the beginning.
To search a track by ZAPPIN mode again,
repeat steps 1 and 2.
Tips
• You can select the playback time from about 6
seconds/15 seconds/30 seconds (page 17). You
cannot select the passage of the track to playback.
• Press (SEEK) +/– or (1)/(2) (ALBUM –/+) in
ZAPPIN mode to skip a track or album.
• Pressing (BACK) also confirms a track to
playback.
14
The part of each track to
playback in ZAPPIN mode.

Sound Settings and Setup Menu

Changing the sound settings

Adjusting the sound
characteristics
1
During reception/playback, press the
select button.
2
Rotate the control dial until the
desired menu item appears, then
press it.
3
Rotate the control dial to select the
setting, then press it.
The setting is complete.
4
Press (BACK).
The display returns to normal reception/play
mode.
The following items can be set (follow the page
reference for details):
EQ7 PRESET (page 15)
EQ7 SETTING (page 15)
POSITION
SET POSITION (Listening Position setting)
(page 15)
ADJ POSITION* 1 (Listening Position
adjustment) (page 16)
SET SW POS* 1 * 2 (Subwoofer Position setting)
(page 16)
BALANCE
Adjusts the sound balance: "RIGHT-15" –
"CENTER" – "LEFT-15."
FADER
Adjusts the relative level: "FRONT-15" –
"CENTER" – "REAR-15."
DM+ (page 16)
RB ENH (Rear Bass Enhancer) (page 16)
SW LEVEL*
2 (Subwoofer Level)
Adjusts the subwoofer volume level: "+10 dB"
– "0 dB" – "–10 dB."
("ATT" is displayed at the lowest setting.)
AUX VOL*
3 (AUX Volume level)
Adjusts the volume level for each connected
auxiliary equipment: "+18 dB" – "0 dB" – "–8
dB."
This setting negates the need to adjust the
volume level between sources.
*1 Hidden when "SET POSITION" is set to "OFF."
*2 When the audio output is set to "SUB-OUT"
(page 17).
*3 When AUX source is activated (page 18).