Ascaso BARCELONA BABY T Manuel De L'utilisateur page 16

In addition to a reservoir connection, the Baby T PLUS has a direct connection to the
water MAINS. It is possible to configure the machine one way or another by configuring
the EP parameter in the settings menu (see Section 12).
To connect the machine to the MAINS water, follow the steps below:
1. Connect the end of the flexible hose (1/8" H connection) to the machine. The
connector is located underneath the machine at the back (see diagram).
2. Connect the end of the flexible hose (3/8" H connection) to the mains water inlet. If
you have installed a water treatment system, connect the hose to the outlet of that
system.
Once the water inlet and drain connections have been made, open the MAINS tap of
the installation to proceed with the start-up.
IMPORTANT!
If you are going to use the MAINS water connection, you must install a stopcock
to stop the flow of water to the machine when necessary.
IMPORTANT: Do not feed the coffee machine with water below 10º Fr hardness.
As an option, this model offers the possibility of a drainage outlet. If you have
this option (KIT.368), be sure to affix the accessory to adjust the height of the
machine's legs, and connect the free end of the drainage pipe provided with the
optional KIT at the general drainage outlet installed previously. You should also
be sure to facilitate the drainage of water from the tray (11) by dismantling the
plug at the back.
Once the water inlet and drain connections have been made, open the MAINS tap of
the installation to proceed with the start-up.
16