ABB ACS880-04F Guide D'installation Rapide page 78

78 Technical data and references
ACS880- Input current
04F-...
U = 480 V
n
459A-5
502A-5
582A-5
634A-5
715A-5
EN
820A-5
880A-5
U = 575 V
DA
n
329A-7
369A-7
DE
429A-7
470A-7
ES
522A-7
590A-7
FI
650A-7
721A-7
1. These UL listed fuses are required for branch circuit protection per NEC.
FR
2. Fuses are required as part of the installation. Fuses are not included in the base drive
configuration and must be provided by others.
IT
3. Fuses with a higher current rating than specified must not be used.
4. Fuses with a lower current rating than specified may be used if they are of the same
NL
voltage and are UL 248 listed fast acting or high-speed fuses.
5. A fuse of a different class can be used at the high fault rating where the I
PL
the new fuse is not greater than that of the specified fuse.
6. Recommended drive fuses must be used to maintain drive UL listing. Additional
PT
protection can be used. Refer to local codes and regulations.
7. When installing a drive always follow installation instructions and NEC requirements.
RU
8. UL 248 listed, fast acting or high-speed fuses from other manufacturers can be used if
they meet the rating requirements specified in the rules above.
9. Alternative fuses can be used if they meet certain characteristics. For acceptable
SV
fuses, see the manual supplement (3AXD50000645015).
In multicable installations, install only one fuse per phase (not one fuse per conductor).
TR
ZH
All manuals and user guides at all-guides.com
(A)
A V
459 600 600
502 600 600
582 800 600
634 800 600
715 1000 600
820 1000 600
880 1000 600
329 500 600
369 500 600
429 500 600
470 600 600
522 600 600
590 800 600
650 800 600
721 800 600
UL fuses
Fuse
Manufacturer UL class
Bussmann
Bussmann
Ferraz
Ferraz
Ferraz
Ferraz
Ferraz
Bussmann
Bussmann
Bussmann
Bussmann
Bussmann
Ferraz
Ferraz
Ferraz
Type
T JJS-600
T JJS-600
L A4BY800
L A4BY800
L A4BY1000
L A4BY1000
L A4BY1000
T JJS-500
T JJS-500
T JJS-500
T JJS-600
T JJS-600
L A4BY800
L A4BY800
L A4BY800
2
and I t of
peak