SCHOLTES TIS 842 Mode D'emploi page 25

Error codes
Error code: Description:
C The cooking zone can be config-
ured if a static "C" is shown.
C/- The cooking zone will be config-
ured if a blinking "C" is shown. After
a successful configuration the rel-
evant display shows "-". When the
"-" is not displayed please check
the possible causes of the E/5.
E
A blinking "E" on each cooking
zone indicates, that all configs will
be deleted.
E/2
Temperature limits are excessed. Electronik temperature to high.
E/3 Unsuitable pot.
E/4 Unconfigured induction modul.
E/5
No communication between UI and
induction modul.
E/6
Main power disturbance.
E/8 Fan failure.
E/9
Defect T sensor on inductor.
E/A
Hardware defect of induction
modul.
E/C
Configuration failure.
E/H Fixed sensor value.
ER31/ER47 Control board.
ER 22 The control board switches off after
3,5-7,5 seconds.
The control board switches off after
ER 03/
10 seconds.
ER20 Error in the control board.
If he cook-
-
ing level is
restored to
0.
L No error! All functions are blocked. -
All manuals and user guides at all-guides.com
Possible causes:
It's not an error, the user is in the
service menu.
The user is in the service menu,
it's not an error.
The user is in the service menu,
it's not an error.
Pot creates on the modul an im-
proper operating point which can
destroy devices, e.g IGBT'.
Induction modul is not configured. 1. Delete the hob configuration and
No power supply of induction
modul.
1. Failure in main power frequency
detection.
2. Over voltage.
Fan or control electronic is defect. Contact the technical Service.
Sensor signal out of valid range;
sensor or electronic is defect.
Defect hardware device detected
by the self check of the modul.
2 cooking zones are dedicated to
the same element of the UI.
-
Error in the control board.
Error in the control board.
Presence of liquids or pans on the
control area.
Memory error.
Failure on the induction module.
Error recovery:
A suitably pan must be placed on
the relevant cooking zone.
Wait for the sysmbol "-" or abort the
configuration activities by pressing
the selectkey and the "C" does not
blink anymore.
Manual configuration.
System must cool down.
1. The error is automaticly can-
celled after 8s and the cooking
zone can be used again. In case
of further upcoming errors the pot
have to be changed.
activate the manual configuration.
2. Start the UI service menu to
configure the induction modul.
Contact the technical Service.
Contact the technical Service.
Contact the technical Service.
Contact the technical Service.
1. Erase the actual configuration
manual configuration with service
menu.
System must cool down.
Contact the after-sales service.
Contact the after-sales service.
Clean the glass-ceramic surface.
Contact the after-sales service.
Contact the after-sales service.
Deactivate the key function.
GB
25