Install Custom Panel - Option 2; Choose Attachment Option - KitchenAid W10275503B Instructions D'installation

Install Custom Panel – Option 2
(Models KUDC03IV and KUDS30IV)
All models require an accessory option to attach custom
panels. Kit Number 8171555 (black), 8171556 (white) or
8171557 (biscuit) are available. To order, call customer
service at 1-800-444-1230.
NOTE: A custom full-front panel must weigh no more
than 14 lbs (6.3 kg) and must be made to specific
dimensions. It is recommended that a cabinetmaker cut
the custom panel because of the precise dimensions
needed.
IMPORTANT: Use a moisture-resistant sealer on both
sides and all edges of the panel to avoid damage from
humidity.
NOTE: These dimensions are for frameless custom panel
models with a 4" (10.2 cm) console only.
1 Custom panel installation -
Dishwashers with control
panel on the front
23³⁄₈"
(65.8 cm)
³⁄₄"
(19.1 mm)
* This dimension is for 4" (10.2 cm) toe kick. If the
installation needs a higher toe kick, adjust the height
of the wood panel accordingly. Not recommended for
toe kicks greater than 6" (15.2 cm).
With a TORX screwdriver, remove three screws from
®
both sides, as shown; hold the outer panel up while
removing the screws. Save screws for reinstallation.
Custom panel dimensions—
2
Dishwashers with control panel
on the front
3 screws
per side
outer panel
Gently set outer panel aside. Lay the cutomer-supplied
custom panel face down on a non-scratching surface.
Position the outer panel on the back of the customer-supplied
custom panel as shown; make sure top edge of the outer
panel is aligned with the top edge of the customer-supplied
custom panel, and both panels are centered side to side.
*25²⁹⁄₃₂" (65.8 cm)
¹⁄₈" (3.2 mm)
¹⁄₈"
(3.2 mm)
3
Mark pilot holes
Mark all four hole locations; remove outer panel and drill
³⁄₃₂" pilot holes ¹⁄₂" (13 mm) deep, in customer-supplied
custom panel. Place the outer panel on the back of the
customer-supplied custom panel and align holes. Attach
outer panel to back of customer-supplied custom panel
with four #10 x ¹⁄₂" wood screws (not supplied). If the
customer-supplied custom panel is less than ³⁄₄" (1.9 cm)
thick where the screws are attached, shorter screws may be
required.
4
Attach body panel
Reinstall
3 screws
each side
Attach the panel assembly to the door by reinstalling the
three screws on each side.

Choose Attachment Option

Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
Using 2 or more people, stand the dishwasher up.
Mark pilot
holes
Align top
edges
Customer-supplied
panel
17