EINHELL GP-CM 36/47 S Li BL Instructions D'origine page 24

curely seated in the lock.
Using the mulching adapter (Fig. 5a)
In mulching mode the cuttings are shredded in
the enclosed mower housing and then spread
back onto the lawn. It is not necessary to gather
and dispose of the grass.
Important! Mulching is only possible if the
lawn is relatively short.
Warning!
Insert the mulching blade only when the machine
has been switched off , the safety plug (12) has
been pulled out and the batteries (16) removed.
To use the mulching function, disconnect the
catch bag, slide the mulching adaptor (Fig. 5a/
Item 18) through the ejector opening and close
the ejector fl ap again.
Side ejector (Fig. 5b)
You must fi t the mulching adapter (18) in order to
use the side ejector. Hook in the side ejector ad-
apter (19) as shown in Fig. 5b.
Charging the battery (Fig. 10-12)
1. Take the battery pack out of the equipment.
Do this by pressing the pushlock button.
2. Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. Insert the power plug of the charger
(17) into the socket outlet. The green LED will
then begin to fl ash.
3. Insert the battery pack (16) into the battery
charger (17).
4. In the section entitled „Charger indicator" you
will fi nd a table with an explanation of the LED
indicator on the charger.
The battery pack can become a little warm during
the charging. This is normal.
If the battery pack fails to charge, check:
•
whether there is voltage at the socket outlet
•
whether there is good contact at the charging
contacts.
If the battery pack still fails to charge, send
•
the charging unit
•
and the battery pack
to our customer service center.
Anl_GP_CM_36_47_52_S_Li_BL_SPK13.indb 24 Anl_GP_CM_36_47_52_S_Li_BL_SPK13.indb 24
GB
To ensure that items are properly packaged
and delivered when you send them to us,
please contact our customer service or the
point of sale at which the equipment was
purchased.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
Fitting the battery (Fig. 12a/12b)
Open the battery covering hoods (Item 4). Then
insert the batteries in the mounts as shown.
For optimum mowing results and battery power
performance it is always best to use batteries with
the same capacity.
It is also possible to use batteries with diff erent
capacities in the battery mounts A and B (Fig.
12a).
Always make sure, however, that you use only
batteries of the same capacity in each separate
battery bank (Fig. 15).
For example, you could use two 4.0 Ah batteries
in one battery bank while using two 5.2 Ah batte-
ries in the opposite battery bank.
Important!
Use only batteries which are charged to the same
level. Never combine full and half-full batteries. Al-
ways charge the two/all batteries simultaneously.
The equipment's operating time depends on the
battery with the lower charge level. The two/all
batteries must always be fully charged before use.
Close the battery cover by swinging it down, and
make sure that it latches in place correctly.
Battery capacity indicator (Fig. 10)
Press the button for the battery capacity indicator
(Fig. 10/Item A). The battery capacity indicator
(Fig. 10/Item B) shows the charge status of the
battery using 3 LEDs.
The charge level can also be read from the indi-
cator (Fig. 6 / Item 22) on the upper long handle.
The indicator does not work in the case of batte-
ries with switching function (e.g. 4-6 Ah).
- 24 -
05.07.2023 13:14:52 05.07.2023 13:14:52