Transport, Packaging And Storage; Commissioning, Operation - WIKA A2G-60 Mode D'emploi

5. Transport, packaging ... / 6. Commissioning, operation

5. Transport, packaging and storage

5.1 Transport
Check the duct/immersion temperature sensor for any damage that
may have been caused by transport. Obvious damage must be reported
immediately.
5.2 Packaging
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during trans-
port (e.g. change in installation site, sending for repair).
5.3 Storage
Permissible conditions at the place of storage
Storage temperature: -20 ... +85 °C
Protect the instruments from moisture and dust.

6. Commissioning, operation

Installation and mechanical connection
Protect measuring instruments from contamination, high temperature
■
changes and vibrations
In order to avoid any additional heating, the instruments must not
■
be exposed to direct solar irradiation while in operation.
The duct/immersion temperature sensor can be fastened directly
■
to the ventilation duct using either a mounting flange or screws.
WIKA operating instructions air2guide model A2G-60
GB
9