Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
EN
3.2. Replacing the bulb
Your BEEM® is supplied with 6 (BEEM® 230, BEEM® 290) or 8 (BEEM® 390,
BEEM® 520) G4 halogen bulbs of 12V/16 Watt . The maximum permitted
output power is 100 Watt. The electrical supply must be disconnected via
the installation's main switch or by disconnecting the plug before the bulb
can be replaced.
You can replace the bulb by carefully sliding the glass upwards, turning it
and remove it. The bulb is held in place in a socket with an internal spring.
Take the bulb out by pulling it gently vertically so it becomes detached
from the socket. Subsequently insert another bulb. Please be careful
never to touch the halogen bulb with your own bare fingers, as this will
significantly reduce the bulb's life.
3.3. Inspection
The BEEM® must be subjected to an annual inspection.
The user is not authorised to carry out his own inspections and repairs.
Inspection of the BEEM® must exclusively be carried out by qualified and
authorised technicians, in accordance with Heatsail's applicable standards
and regulations. Qualified people are understood to mean: people who
have completed a technical training course for the installation of outdoor
heating and who are familiar with the applicable electricity laws and
regulations.
The electrical supply must be disconnected via the installation's mains
switch or by disconnecting the plug before any work can be carried out.
All repairs must be requested via Heatsail.
A repair is only valid when original parts have been used. The entire
control panel should be returned in case of a defective cable, once written
approval has been provided by Heatsail.
Heatsail will not be held responsible for damage resulting from non-
compliance with the instructions regarding maintenance.
4.
Guarantee conditions
User manual
49
Publicité
