Tanaka TCH 22EA2 50ST Mode D'emploi page 4

English
MEANINGS OF SYMBOLS
NOTE: Some units do not carry them.
Symbols
WARNING
The following show symbols used for the machine. Be sure that you understand their meaning before use.
It is important that you read, fully understand and
observe the
warnings. Careless or improper use of the unit may
cause serious or fatal injury.
Read, understand and follow all warnings and
instructions in this manual and on the unit.
Always wear eye, head and ear protectors when using
this unit.
Choke - Run position (Open)
Choke - Choked position (Closed)
On/Start
Off /Stop
Contents
WHAT IS WHAT? .............................................................................. 5
WARNINGS AND SAFETY INSTRUCTIONS .................................. 6
SPECIFICATIONS ............................................................................ 7
OPERATING PROCEDURES ........................................................... 7
MAINTENANCE ................................................................................ 8
TROUBLESHOOTING ...................................................................... 9
4
(Original instructions)
following safety precautions and
Emergency stop
Fuel and oil mixture
Hot surface
Guaranteed sound power level
Before using your machine
• Read the manual carefully.
• Check that the cutting equipment is correctly
assembled and adjusted.
• Start the unit and check the carburetor adjustment.
See "MAINTENANCE".