Taski ergodisc omni Traduction Des Instructions Originales page 44

Malfunctions
Malfunction
Machine without function
Tool does not rotate
Machine has no function, indicator
light is on
Machine does not reach nominal
speed, overcurrent is activated
Machine does not run smoothly
Spray pump is running, cleaning
product is not released
Technical information
Machine
Working width
Dimensions (LxWxH)
Maximum weight of operational machine
Rated voltage
Frequency
Rated power, nominal
Values according to IEC 60335-2-67
Sound pressure level LpA
Uncertainty KpA
Vibration
Uncertainty K
Splash water guard
Protection class
Accessories
No. Item
8505440 Splash guard
Various pads (pink, red or special pads)
42
All manuals and user guides at all-guides.com
Possible causes
Machine is switched off
No power supply
Main cord defect
Motor does not turn
Defective safety switch
Motor runs, but tool does not rotate
Defective electronic component
Machine overload, overload switch
was activated
Machine overload
Undervoltage: Main cord is too long
Pad deformed or damaged
Cleaning product dried in the spray
unit or hose blocked
Troubleshooting
• Switch on the main switch
• Insert the plug into the mains sock-
et
• Replace the main cord
• Contact your service partner
• Contact your service partner
• Drive belt torn or loose
• Contact your service partner
• Contact your service partner
• Wait a few minutes and try again
(overload switch resets automati-
cally)
• Check the work technique
• Remove power supply cord exten-
sion
• Check the voltage rating
• Replace pad
• Clean spray unit
• Replace spray unit
omni
43
76 x 48 x 119
44
230-240V~
50
1400
65
2.5
< 2.5
0.25
IPX0
I
Page
38
41
cm
inches/
cm
kg
AC
Hz
W
dB(A)
dB(A)
m/s2
m/s2