Villaware NDVLEM1000 Mode D'emploi page 8

Functions:
Quick Start
Center Control Knob
Press the center of the knob
to power unit ON and OFF.
Brew Mode
This function is to brew espresso.
Press this function to initiate
brew pre-heat (light on brew
mode will pulse).
when light stays solid, turn
control knob to Brew Start to
brew espresso, then turn back
to center to stop.
Froth Mode
This function is to froth milk.
Press this function to initiate
froth pre-heat (light on froth
mode will pulse).
when light stays solid, turn
control knob to Froth Start to
froth milk, then turn back to
center to stop.
How To:
Brew Espresso
PREPARATION PREPARATION
Gather the following prior to brewing:
Fine espresso ground coffee
1
Tap water (or, preferably, your favorite
2
filtered water)
Teaspoon
3
Your favorite cups/demitasses
4
NOTE: The top of the Espresso Maker is a
warming zone for your cups. Any time the
unit is on, the warming zone will be warm.
Next
Make sure the knob is in the OFF position.
5
Fill the reservoir with water. You may
6
either use bottled water or a pitcher to fill
it up, or remove it from the unit and then
fill it up under the tap. Fill the reservoir
with the desired amount of water
ensuring it ranges within the "MIN" and
"MAx" markings on the tank.
Never use warm or hot water to fill the
water reservoir.
If you have removed the reservoir from
the unit to fill up with water, please make
sure to place it back flush against the back
of the Espresso Maker.
It is important to place the black plastic
tabs on the back of the water reservoir
firmly into the
tab slots on
the back of
the Espresso
Maker. This
will ensure
proper fit of
the water
reservoir and
proper water flow into the pump.
Close the water reservoir lid.
7
5
villaware.com villaware.com