AERMEC VMF-E5 Manuel D'utilisation page 59

• Assign the set for ALL the fancoils:
Set fancoils
19.7
SetPoint: UNLOCKED
Mode : LOCAL
ESC
D E
A
o
C
B
C
F G
From this window it is possible to:
(1) assign the work set to which to force ALL the fancoils
during the "lock settings" function:
The set temperature represents the room temperature that the
fancoils reach in the specifi c zone; to set this value proceed
as follows:
(1) Enter edit mode by pressing the key
this key the digits representing the set temperature will start
to fl ash.
(2) Press the key to increase the value selected, or the key
A
to decrease it;
B
(3) Press the key to confi rm the value entered; once this
C
key is pressed, the set digits will have stopped fl ashing,
indicating that the editing process has been completed;
(2) set the block of the changes on the set point from the
panel on board the machine:
pressing the key it is possible to lock or unlock the set
E
point change from the panel on board the machine; this state
is specifi ed by the "set point" string value on the display:
- LOCKED indicates that it will not be possible to change the
set point from the terminal on board the machine (VMF-E2 or
MVF-E4);
- UNLOCKED indicates that it will be possible to change the
set point from the terminal on board the machine (VMF-E2 or
MVF-E4);
(3) set the mode of operation where the thermostat on board
the machine is locked:
pressing the key F or G it is possible to select the mode to
be activated on the fancoil selected:
- LOCAL indicates that it will be possible to change the mode
from the panel on board the machine;
- AUTO (the unit will operate in automatic mode, on the basis
of the temperature set assigned and the room temperature
detected). This mode cannot be changed from the panel on
board the machine;
- V1, V2 or V3 (indicate the rate of ventilation set). This mode
cannot be changed from the panel on board the machine;
- AUX (indicates that the accessories connected to the fancoil
have been activated; for more information on the accessories
available for each fancoil refer to the documentation of the
unit). This mode cannot be changed from the panel on board
the machine;
After completing insertion of the work set, it will be possible
to:
- Go to the next window by pressing the key
- Go to the previous window by pressing the key
- Return to the menu selection by pressing the key
C ; after pressing
;
A
B ;
D ;
59
GB
6795770_02