Franke CM 85 M Conseils D'utilisation Et D'installation page 21

All manuals and user guides at all-guides.com
End of cooking ( ) with delayed start ( )
Delayed start of cooking can only be activated following the end of a cooking process; when set, pressing the right knob
confirms the "stop", and at the same activates the blinking LED for the symbol . Turn the left knob to also set the
start of cooking time (naturally this will be before the end, therefore the hands can only be moved back). Confirm by
pressing the right knob again. The data can also be automatically acquired by allowing the blinking to continue for
10 seconds. The LEDs for symbols and remain lit and the oven will switch on at the set time, when only the
LED for the symbol will remain lit.
At the end of cooking, the ringer will sound for 1 minute; this sound can be stopped by pressing the right knob.
Setting the time of day ( )
To set the correct time, just press the right knob three times (the LED for the clock symbol starts blinking), then turn the
left knob. After setting the right time, press the right knob to confirm.
Electronic cooking programmer
It enables oven programming in the following modes:
B
• delayed start of cooking with set duration;
• immediate start of cooking with set duration;
• timer.
Setting the digital clock
When the appliance has been connected to the mains or after a power failure the
display will flash on: "0.00".
Press the + and – buttons together for a few seconds. The time of day can be
adjusted with the + and – buttons, while the dot between the hours and minutes
flashes. If the time setting mode is selected when an automatic programme is
active, the automatic programme is cancelled.
Possible time adjustments can be made by repeating the steps described above.
Acoustic signal frequency modification
B
The frequency of the acoustic signal can be changed if a cooking cycle is not
programmed (therefore the display shows the time of day). Press the + and –
buttons (from the time modification menu) together, then press Mode or Set to
select the menu for modifying the acoustic signal frequency. The acoustic signal
frequency can be modified by repeatedly pressing the Mode or Set button; "ton1",
"ton2", "ton3" will appear on the display.
Manual oven operation
Once the time has been set, the programmer automatically switches to manual
mode.
Starting delayed cooking with set duration
When the time of the day is displayed, press the Mode or Set button twice to set a duration, then press it again to set the
end of cooking time. Set the required time with the + and – buttons. During duration or end time adjustment mode
selection, the Auto symbol remains lit.
Once a programme duration is set, the end time cannot be decreased. Likewise, the duration of a programme cannot be
prolonged once the end time is set.
The end time and duration settings define programme start time as follows:
start time = end time - duration.
After setting the duration and end time, the display still shows the end time. The programme starts when the time of day
coincides with the start time: the Auto symbol lights up steadily and the symbol starts flashing. After the start of
cooking, the display shows the countdown. If only the end of cooking time is selected (the duration is = 0), cooking
starts and the display shows the countdown.
The Auto symbol remains lit during the wait for delayed start and for the entire duration of cooking.
The symbol flashes during the wait for delayed start and remains fixed when cooking starts.
20