GreenWorks GPW1704 Manuel De L'utilisateur page 8

EN
Before you change the nozzle:
1. Pull the gun trigger to release water pressure.
2. Lock the trigger safety button on the gun.
3. Stop the mahcine.
Do not point the spray wand at your face or others'.
12.3.1 NOZZLE TYPE
SPRAY TIP APPLICATION
White - Wide fan tip (40° )
•
40
O
Turbo Nozzle Tip
•
12.3.2 INSTALL THE NOZZLE
1. Pull back the quick-connect collar on the spray wand (5).
2. Install the nozzle (3) onto the spray wand (5).
3. Release the quick-connect collar to attach the nozzle (3).
12.4 INSTALL THE DETERGENT TANK
Do not use household detergents, acids, alkalines, bleaches,
solvents, flammable material, or industrial grade solutions,
which can do damage to the pump.
Do the instructions on the solution bottle to prepare
detergent.
WARNING
WARNING
The white 40 degree tip, referred to
as the "fan" tip creates the widest
area of cleaning with relatively low
pressure. This pressure washer tip is
best used for light or delicate clean-
ing applications. It is recommended
for light cleaning on wood decks and
other soft or delicate surfaces.
The nozzle rotates in a zero to 15 de-
gree spray pattern in a circular mo-
tion to break down tough dirt and
grime. The spray pattern can cover
area of 4 to 8 inches wide, depending
on a distance between the tip and the
surface being cleaned.
WARNING
WARNING
English
If it is necessary, use a funnel to prevent the spill of
detergent. Clean and dry the spilled detergent when you fill
it.
1. Put the detergent into the detergent tank (9).
2. Install the detergent tank (9) onto the gun (6).
3. Turn counter-clockwise the gun (6) to tighten.
Do not let detergent dry on the surface to prevent streaks.
12.5 START THE MACHINE
Do not operate without the water supply connected.
Before you start the machine:
1. Turn the water supply on.
2. Pull the gun trigger to release air pressure.
3. If a stable stream of water comes out from the gun,
release the gun trigger.
1. Connect the machine to the power supply.
2. Set the power switch to the "ON" ( | ) position.
3. Turn the water supply on.
4. Pull the gun trigger.
12.6 STOP THE MACHINE
1. Release the spray gun trigger.
2. Press down on the ON/OFF switch, once again, to set the
power switch to the "OFF" (O) position.
8
NOTE
NOTE
CAUTION
CAUTION