Electrolux SB 269 11 Notice D'utilisation page 8

8 electrolux
1
7. Unscrew the upper hinge pivot (t1) and screw
it on the opposite side.
Environmental concerns
The symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it should be taken to the
appropriate collection point for the recycling of
electrical and electronic equipment. By ensuring
this product is disposed of correctly, you will help
prevent potential negative consequences for the
All manuals and user guides at all-guides.com
8. Remove the left-hand cover pin of the middle
9. Fit the pin of the middle hinge (m5) into the left-
10. Re-insert the lower door on the lower hinge
11. Fit the upper door on the upper hinge pivot
12. Re-insert the upper door on the middle hinge
13. Re-screw the middle hinge (m2). Do not forget
14. Reposition, level the appliance, wait for at least
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the cabinet.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter),
the gasket may not fit perfectly to the cabinet. In
that case, wait for the natural fitting of the gasket.
In case you do not want to carry out the above
mentioned operations, contact the nearest After
Sales Service Force. The After Sales Service spe-
cialist will carry out the reversibility of the doors at
your cost.
environment and human health, which could
otherwise be caused by inappropriate waste
handling of this product. For more detailed
information about recycling of this product, please
contact your local council, your household waste
disposal service or the shop where you purchased
the product.
hinge (m3,m4) and move to the other side.
hand hole of the lower door.
pivot (b2).
(t1).
pivot (m5) slightly tilting both doors.
the plastic spacer (m1) inserted under the mid-
dle hinge. Make sure that the edges of the
doors run parallel to the side edge of the ap-
pliance.
four hours and then connect it to the power
socket.