Basic Operations Of Dab - Sony CDX-M770 Mode D'emploi

Basic operations of DAB

Searching for the ensemble and
service
— Automatic Tuning
1
Press (SOURCE) repeatedly to select
the radio.
2
Press (MODE) repeatedly to select
"DAB."
3
Press and hold either side of (SEEK)
until "Seek +" or "Seek –" appears.
The unit will stop seeking when an ensemble
is located. The unit will then automatically
select the first service and display its name,
and the display indicator will change from
"Seek +"/"Seek –" to the service name.
4
Press either side of (SEEK) to select
the desired service.
Selecting the ensemble
— Manual Tuning
If you know the channel number of ensemble,
follow the procedure below to tune in.
1
Press (SOURCE) repeatedly to select
the radio.
2
Press (MODE) repeatedly to select
"DAB."
3
Press M or m until "Ch. XXX" appears.
4
Press M or m repeatedly until the
desired channel number appears.
22
Receiving the preset services
Following procedure is available after presetting
the service. For details on presetting the services,
refer to "Presetting DAB services automatically,"
(page 23) and "Presetting DAB services
manually" (page 23).
1
Press (SOURCE) repeatedly to select
the radio.
2
Press (MODE) repeatedly to select
"DAB."
3
Press M or m repeatedly to select the
preset service.
Tip
There is another way to receive the preset service
(preset on numbers 1 to 6).
Press the number button ((1) to (6)) on which the
desired service is stored.
Refer to the level indication to check the
receiving condition of the DAB programme.
The level indication increases as the
strength of the receiving signal increases.
level 0 level 1 level 2
" " will flash in the display if the reception is
poor.
Note
To display the level indication, select the spectrum
analyzer pattern A-1 or A-2 (page 33).
level 3 level 4