Publicité
Les langues disponibles
Les langues disponibles
Problem/
Indication on the display unit
error
and problem description
Water detected at the bottom
of the washing machine
(Total Aqua Stop system)
E9
Water level sensor error.
E10
Water overflow
E11
Motor control error
E12
Error while locking the door.
E22
Error while unlocking the door.
E23
Electronics communication
failure in the washing machine
E36
Electronics communication
failure in the washing machine
E37
Water drain system alert.
Symbol
will appear.
Unevenly distributed laundry
When the washing programme
is complete, the symbol
remain lit on the display unit.
System warning to run the Steril
tub (Self-cleaning programme)
cln
After the washing programme
is complete, the signs »cln«
and »End« will alternate on the
display unit.
What to do?
Turn off the appliance and turn it back on. If the error reoccurs,
call a service technician.
Unplug the power cord from the outlet; then, plug the power cord back
into the outlet and switch on the washing machine. If the error reoccurs,
call a service technician.
If there is water in the drum that exceeds a certain level, and an error is
reported on the display unit, the washing program will be interrupted
and water will be pumped out of the washing machine. Restart the
programme. If the error reoccurs, call a service technician. If there is
water in the drum that exceeds a certain level, and an error is reported
on the display unit, while the washing machine continues to add water,
close the water tap and call a service technician.
Restart the programme. If the error reoccurs, call a service technician.
Door is closed, but it cannot be locked. Switch off the washing machine.
Switch it back on and restart the washing programme. If the error
reoccurs, call a service technician.
Door is closed, but it cannot be unlocked. Turn off the washing machine,
then turn it back on. If the error reoccurs, call a service technician.
To open the door, see chapter »INTERRUPTIONS AND CHANGING
THE PROGRAMME/Opening the door manually«.
Unplug the power cord from the outlet; then, plug the power cord back
into the outlet and switch on the washing machine. If the error reoccurs,
call a service technician.
Unplug the power cord from the outlet; then, plug the power cord back
into the outlet and switch on the washing machine. If the error reoccurs,
call a service technician.
Alert about reduced water flow in the pumping stage. Check the following:
• is the pump filter clean,
• is the discharge hose clogged,
• is the drain clogged,
• if the discharge hose placed is placed below the maximum and above
the minimum height (see chapter »INSTALLATION AND CONNECTION/
Connecting and securing the water discharge hose«).
Manually distribute the laundry and run the spinning programme.
will
See additional description under TROUBLESHOOTING TABLE.
We recommend running the Steril tub [trommelreiniging]
(Self-cleaning programme).
51
English
•
Publicité
