Inventum VWM9001B Mode D'emploi page 49

CLEANING THE INLET FILTER AT THE BACK OF THE APPLIANCE
1. Close the water tap.
2. Unscrew the water supply hose from the back of the appliance.
3. Pull out the filter with a long nose plier and clean the filter using a brush under
running water.
4. Reinstall the filter to the water inlet and reconnect the water supply hose.
5. Open the water tap.
CLEANING THE DISPENSER TRAY
1. Press the small tab and pull the dispenser tray out of the recess.
2. Clean the dispenser tray under running water using a brush, and dry it.
Also, remove any detergent residue from the bottom of the housing.
Make sure not to forget to clean the drain hole of the softener compartment
and the openings at the bottom of the dispenser tray.
3. Clean the inside of the recess with a brush.
4. If required, remove and clean the plug cap.
5. Clean the plug cap under running water and replace it.
6. Push the dispenser tray back in the recess.
i
• Do not use abrasive or caustic agents to clean plastic parts.
• Cleaning the dispenser tray every 3 months ensures normal operation
of the appliance.
CLEANING THE DRAIN PUMP FILTER
The pump filter can filter the yarns and small foreign matters from the washing. Especially after washing fleecy, woolly or
very old laundry.
Clean the pump filter and the in-wall water trap whenever the symbol
WARNING!
• Unplug the appliance to avoid electrical shock before cleaning.
• Be careful of hot water!
• Allow detergent solution to cool down.
• During cleaning, some water may be spilled. It is recommended to place an absorbent cloth on the floor.
1. Open the pump filter cap using a suitable tool (flat screwdriver or
a similar tool).
2. Pull out the water outlet funnel before cleaning the pump filter. Rotate
the pump filter slowly in the counter clockwise direction. Pull out and
remove the pump filter to allow the water to drain slowly.
3. Clean the pump filter thoroughly under running water.
4. Remove all and any objects and impurities from the filter housing and
the pump propeller. Replace the pump filter as shown in the figure
and fasten it by rotating in the clockwise direction. For a good seal,
the filter gasket surface should be clean.
WARNING!
• Never remove the pump filter cap during a washing cycle. Always wait
until the appliance has finished the cycle and is empty.
• When the appliance is in use and depending on the selected
programme, there can be hot water in the pump.
• When replacing the pump filter cap, ensure it is securely snapped
in place.
1
appears on the display unit.
2
49
English •