Publicité
Les langues disponibles
Les langues disponibles
Page 6 of 27
PICTURE 15
Remove the seat using the key.
•
•
Remove the four bolts that hold the seat catch as arrowed in picture 1
using 4mm Allen key. Remove the seat catch.
•
Remove the two bolts that hold the tool holder as arrowed in picture 2
using 4mm Allen key. Remove the tool holder tray.
Remove the four bolts that hold the seat lock mechanism as arrowed in
•
picture 3 using 4mm Allen key. Remove seat lock mechanism (It is not
necessary to detach the cable and remove the seat lock mechanism
completely)
Disconnect the 4 electrical connectors (taillight, L/H indicator, R/H
•
indicator and no. plate light connectors) as arrowed in picture 4. Please
note the orientation of the connectors for re-fitting at later stage.
•
Remove the 3 bolts that hold the undertray cover as arrowed in picture
5 using 5mm Allen key. Remove the undertray cover.
•
Remove the four main bolts that hold the tail unit assembly as arrowed
in picture 6 using 6mm Allen key. From below, using a 6mm Allen key
hold still the four button head shape nuts while the four main bolts are
being loosen, this is to stop the nuts from turning (Arrowed in picture
7). Please keep the tail unit assembly supported during removal as it
may drop and cause damage to the wiring loom. Gently retract the
whole tail unit assembly and the wiring loom away from the sub-
frame/ bike.
FITTING INSTRUCTIONS
LP0339
PICTURE 16
Publicité
