Installing The Range Into The Cabinets; Adjusting The Leveling Legs; Sliding The Range Into The Opening - Bosch HEI8056C Instructions D'installation

en-us Installing the range into the cabinets
Properly secure the flexible conduit at knockout on an-
2.
gle and at the supply side junction box. The wiring is
now complete.
Note: DO NOT connect electrical power to the range at
this time.
Installing a three-wire flexible conduit connection
Follow the instructions for installing a three-wire con-
1.
nection. → Page 10
r Red
g Green
b Black
Properly secure the flexible conduit at knockout on an-
2.
gle and at the supply side junction box. The wiring is
now complete.
Note: DO NOT connect electrical power to the range at
this time.
7 Installing the range into the cabinets

Installing the range into the cabinets

Installing the range into the cabinets
7.1 Adjusting the leveling legs
Line up the range in front of opening.
1.
Measure the height at the back left corner of the
2.
opening from the top of the countertop to the floor.
12
Measure the height
3.
range from the underside of the cooktop to the bottom
of the range.
Adjust the leveling legs until the dimensions
4.
are the same.
Repeat in the back right corner.
5.
Use a 1¼ " wrench to adjust the front leveling legs so
6.
that the height from the underside of the cooktop to the
floor matches the height of the corresponding counter-
top surface.
Warming drawer
Wrench
Adjustable leveling legs
7.2 Sliding the range into the opening
CAUTION
Unit is heavy and requires at least two persons or proper
equipment to move.
It is recommended to wear protective clothing during the
lifting process.
Wear gloves and long sleeves to protect hands and
▶
forearms from abrasion and potential scratches.
Take off watches and jewelry.
▶
Wear work shoes for foot protection.
▶
NOTICE:
To avoid risk of damage to the range oven door, do not lift,
push, or pull the range by holding the door handle.
at the back left corner of the
and