Reinstalling The Oven Door; Removing The Warming Drawer From The Drawer Housing - Bosch HEI8056C Instructions D'installation

Masquer les pouces Voir aussi pour HEI8056C:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Requirement: You have removed the oven door.
1.
CAUTION - Risk of crushing! DO NOT attempt to
lift the unit by holding the oven's upper heating element.
Lift the range off of the packaging base. Reach inside
the top of the oven cavity to locate a ridged area near
the front of the oven.
Make sure that the circuit breaker is off and then plug
2.
the range cord into the electrical outlet.
Dampen the countertop and floor at the bottom of the
3.
opening with soapy water.
Slide the range into the opening. Be careful not to dam-
4.
age countertops, floors, or warming drawer front. Do not
apply pressure to the cooktop when sliding the range
into position. Be careful not to crimp the flexible electri-
cal connector.
Install the oven door. →  Page 13
5.
Check proper installation.
6.
– The cooktop should rest lightly on the countertop.
– There should not be any gap between the countertop
and the cooktop; however, the weight of the range
must not rest on the countertop.
– Look under the range to verify that both back legs are
resting solidly on the floor.
– Also verify that the left range leg is retained by the
anti-tip bracket.
7.3 Reinstalling the oven door
Hold the door firmly in both hands. Grip it on either side,
1.
not by the handle.
Tilt the door back slightly towards you at an angle that
2.
would open the door about 7" (18 cm) at the top.
Installing the range into the cabinets en-us
Slide the hinges
into the slots
3.
and lower the door straight down
The angle of the door may need to be adjusted slightly
to allow the hinges to engage properly and the door to
be lowered into place. The door should lower about
3/4" (2 cm) and stop. If it does not, the hinges have not
engaged properly and the door could fall if it is released.
Once both hinges are fully engaged, gently open the
4.
door until it is fully open.
Push the levers on both the hinges up and forward until
5.
they are locked into the slot and flush with the front of
the oven body.
Close and open the door slowly to be sure it is correctly
6.
and securely in place.
7.4 Removing the warming drawer from the
drawer housing
WARNING
To prevent burns, do not remove the drawer while hot.
Be sure the drawer is empty before removing.
The warming drawer has a push-to-open (PTO) mecha-
1.
nism. Press on the center of the warming drawer front
panel to open it.
as far as they will go
⁠ .
13

Publicité

Table des Matières
loading

Table des Matières