Hilti TE 1000-AVR Manuel D'utilisation page 10

Noise information and vibration values determined in accordance with EN 60745-2-6
Chiseling (a )
h, Cheq
Uncertainty (K)
5 Operation
5.1 Fitting and adjusting the side handle
CAUTION
Risk of injury! Loss of control over the breaker.
▶ Check that the side handle is fitted correctly and tightened securely.
▶ Fit or adjust the side handle.
Note
The instructions provided with the side handle must also be observed.
5.2 Fitting / removing the accessory tool
WARNING
Risk of injury! The accessory tool gets hot during use and may also have sharp edges.
▶ Wear protective gloves when changing the tool.
DANGER
Risk of fire! Risk of contact between the hot accessory tool and highly inflammable materials.
▶ Do not lay the hot accessory tool down on highly inflammable materials.
Note
Check the accessory tool for damage or uneven wear each time before use and replace it if necessary.
Note
Use only the recommended grease supplied by Hilti. Use of unsuitable grease may cause damage to
the product.
▶ Fit the accessory tool or, respectively, remove it.
5.3 Chiseling tips 4
Note
The chisel can be adjusted to 6 different positions (in 60° increments). This ensures that flat chisels
and shaped chisels can always be set to the optimum working position.
▶ Bring the chisel into contact with the workpiece about 80 -100 mm (3¹⁄₈" - 4") from its edge.
▶ When working close to reinforcing bars, always guide the tip of the chisel toward the edge of the
workpiece, not toward a reinforcing bar.
▶ Begin with the chisel positioned at an angle of 70° to 80° to the concrete surface, with the tip of the chisel
pointing toward the edge of the workpiece. Break material away by subsequently increasing the angle to
approx. 90° as the chisel penetrates.
▶ Rotate the chisel regularly to help ensure even wear and to promote the self-sharpening process.
▶ If inadequate pressure is applied, the chisel will jump around uncontrollably. Application of excessive
pressure will result in a loss of chiseling performance.
6
All manuals and user guides at all-guides.com
2
3
5 m/s²
1.5 m/s²