Kenwood KNA-DV3200 Manuel D'installation page 6

Connection
TMC Receiver (Optional)
Cable accompanying
the TMC Receiver
D
Active Speaker
(KNA-SP200)
(Optional)
2CAUTION
When disconnecting the interface cable, pinch and pull
the ring of the connector. If you pull other parts of the
connector, the locking mechanism of the connector is
not released, which may damage the connector.
2WARNING
• Do not cut off the holder marked "S SENS" (containing a protection
diode) of the car speed signal detection cable H (White).
Doing so will cause a fault with the car.
• Please contact your dealer for information about the connection
method. A connection error will lead to car breakdown.
6-
English
To the monitor unit
("NAV I/F" terminal)
To parking brake detection switch harness of car
2WARNING
For the sake of safety, be sure to
connect the parking sensor cable.
To the car speed signal harness
Remote Control Sensor accompanying
the Remote Control
Voice control microphone (Optional)
Audio Output (MONO) (Black)
Visual Output (Yellow)
NOTE
Do not remove the cap when not
connecting the cable.
Wiring harness G
Parking sensor cable (Green)
PRK SW
Car speed signal intermediate
cable H (White)
S SENS
S SENS