Installation Of The Gps Antenna - Kenwood KNA-DV3200 Manuel D'installation

Installation
Installation for Navigation System
2WARNING
Check that there are no wiring cables or other parts beneath the floor mat before cutting the floor
mat.
2CAUTION
• Select for installation a location where the unit can be placed completely horizontal.
• Be sure to firmly stabilise this product. Do not install it in a location which is not stable.

Installation of the GPS Antenna

2CAUTION
• GPS antenna D can be installed either inside or outside of the car, but either way it should be
installed as horizontally as possible to allow easy reception of the GPS satellite signals.
• The reception conditions of the GPS satellite will be less favorable with installation inside the car
as compared to outside the car. Depending on the type of car, reception of the GPS satellite signals
might not be possible with an inside installation. Installation outside of the car is recommended if
circumstances allow.
• The GPS antenna should be installed at a position that is spaced at least 30 cm from cellular phone
or other transmitting antennas. Signals from the GPS satellite may be interfered with by these
types of communication.
• Do not remove the tape from the back of the GPS antenna. When the tape comes off, the
waterproof effectiveness is diminished and this may cause a fault in the GPS antenna.
• Painting the GPS antenna with (metallic) paint may cause a drop in performance.
Installation Outside the Car
Installation to the trunk lid is made with the GPS antenna
D built-in magnet.
Affix the waterproof pad that accompanies E at the
1
place that comes up against the waterproof rubber
lining the trunk.
Draw the cable of D from the trunk lid into the trunk.
2
Installation Inside the Car
Install at a place close to the window surface at the
center of the rear tray or on the inside of the rear
window to allow easy reception of the GPS satellite
signals.
Peel off the release paper of F and affix to placement
1
position of D.
Place D on F.
2
C (Ø5x20mm)
Ø4
B (M5x8mm)
A
Holes for suspension
and attachment
Holes for attachment
D
D
F
E
-5
English