Safety Precautions - Kenwood KNA-DV3200 Manuel D'installation

Safety precautions

2WARNING
To prevent injury and/or fire, take the
following precautions:
• Ensure that the unit is securely installed.
Otherwise it may fly out of place during
collisions and other jolts.
• When extending the ignition, battery or ground
cables, make sure to use automotive-grade
cables or other cables with an area of 0.75mm
(AWG18) or more to prevent cable
deterioration and damage to the cable coating.
• To prevent short circuits, never put or leave
any metallic objects (e.g., coins or metal tools)
inside the unit.
• If the unit starts to emit smoke or strange
smells, turn off the power immediately and
consult your Kenwood dealer.
2CAUTION
To prevent damage to the machine, take
the following precautions:
• Make sure to ground the unit to a negative 12V
DC power supply.
• Do not open the top or bottom covers of the
unit.
• Do not install the unit in a spot exposed to
direct sunlight or excessive heat or humidity.
Also avoid places with too much dust or the
possibility of water splashing.
• Do not subject the faceplate to excessive
shock, as it is a piece of precision equipment.
• When replacing a fuse, only use a new one
with the prescribed rating. Using a fuse with
the wrong rating may cause your unit to
malfunction.
• To prevent short circuits when replacing a fuse,
first disconnect the wiring harness.
• During installation, do not use any screws
except for the ones provided. The use of
improper screws might result in damage to the
main unit.
Cleaning the Unit
If the faceplate of this unit is stained, wipe it
with a dry soft cloth such as a silicon cloth.
If the faceplate is stained badly, wipe the stain
off with a cloth moistened with neutral cleaner,
then wipe neutral detergent off.
2CAUTION
Applying spray cleaner directly to the unit may
2
affect its mechanical parts. Wiping the
faceplate with a hard cloth or using a volatile
liquid such as thinner or alcohol may scratch
the surface or erases characters.
Lens Fogging
Right after you turn on the car heater in cold
weather, dew or condensation may form on
the lens in the DVD player of the unit. Called
lens fogging, DVDs may be impossible to play.
In such a situation, remove the disc and wait
for the condensation to evaporate. If after the
condensation has evaporated the unit still does
not operate normally, consult your Kenwood
dealer.
The marking of products using lasers
(Except for some areas)
CLASS 1
LASER PRODUCT
The label is attached to the chassis/case and says
that the component uses laser beams that have
been classified as Class 1. It means that the unit
is utilizing laser beams that are of a weaker class.
There is no danger of hazardous radiation outside
the unit.
-3
English