Transport - Wilo DrainLift WS 40E Basic Notice De Montage Et De Mise En Service

5.2

Transport

Fig. 3: Attachment points
Installation and operating instructions Wilo-DrainLift WS 40/50 Basic
Transportation and storage
DANGER
Risk of fatal injury if the load is incorrectly secured!
Faulty or incorrect load securing can lead to life-threatening situations! Secure the
load in accordance with local regulations. Check the load is secure before transport!
WARNING
Standing under suspended loads!
Never allow anyone to stand under suspended loads! Danger of (serious) injuries
caused by falling parts. Loads may not be carried over work places where people are
present!
WARNING
Head and foot injuries due to a lack of protective equipment!
Danger of (serious) injuries during work. Wear the following protective equipment:
• Safety shoes
• Safety helmet must be worn if lifting equipment are used!
NOTICE
Use only properly functioning lifting equipment!
Use only properly functioning lifting equipment to lift and lower the pump chamber.
Ensure that the pump chamber does not become jammed during lifting and lower-
ing. Do not exceed the maximum bearing capacity of the lifting equipment! Check
that lifting equipment is functioning properly before use!
To avoid damage during transport, please observe the following points:
ƒ
Always transport the pump chamber on a pallet.
ƒ
Always set down the pump chamber vertically on the pallet.
ƒ
Secure the pump chamber against slipping. When lashing, make sure that the plastic
parts do not deform.
ƒ
Close any openings, ensuring they are sealed watertight.
ƒ
Remove loose accessories from the pump chamber and pack them separately.
ƒ
To avoid damage to the pipework and pipe adaptors, always keep the pump chamber
vertical during transport.
NOTICE! Thoroughly clean used pump chambers before shipping and disinfect them
if necessary.
The following points must also be observed during attachment:
ƒ
Adhere to the applicable national safety regulations.
ƒ
Use legally specified and approved lifting gear.
ƒ
Select the lifting gear based on the existing conditions (weather, attachment point,
load, etc.).
ƒ
Only attach the lifting gear to the attachment point. Fix with a shackle.
ƒ
Use lifting equipment with sufficient bearing capacity.
ƒ
The stability of the lifting equipment must be ensured during operation.
ƒ
When using lifting equipment, a second person must be present to coordinate the
procedure if required (e.g. if the operator's field of vision is blocked).
en
45